build a two panel gate deck

(We also alternated rough and smooth sides so the fence would look identical on both sides.) Most likely you'll have to rip the end boards of each panel to width. Cut and install the top 1×2 pickets (Photo 12).Then screw the last two top rails and the bottom 1×8 rail into place with two 2-in.deck screws into the 1×2 cleats at the 

sliding deck gate sliding on wheels diy wooden deck gate looks like here it is.

Measure between the posts where the gate will go. Subtract 1 inch from that measurement and cut two 2-by-4-inch lengths of deck lumber at a 90 degree angle (straight across).

Two panel gate for our deck made from 2x4s. diytyler.com 2014 08 22 two-panel-2x4-deck-gate Subscribe for more DIY videos https: www.youtube.com use

sliding deck gate a good start with a couple tweaks here and there.

We needed to build and install a gate on the deck to complete the building part of the deck, still need to seal it (eke). Wanted a gate in place to keep the kids on and animals off. This was one of the few times that I did not draw up the work piece in sketchup before starting to build, had an idea in my head and 

Buy great products from our Wooden Gates Category online at Wickes.co.uk. We supply trade quality DIY and home improvement products at great low prices.

Measure for the gate opening and cut the cedar down to size. For this project, the 2x4s were cut to 44 inches for the stiles and two were cut to 27-1 2 inches for the rails with a cross brace of 46-1 8 inches. NOTE: Decide the width of the gate opening, then factor in a slight gap of approximately 1 inch, so there's room for the 

We also needed to create a dado on part of the side boards (there are 2). We marked both boards 51.5 inches away from the bottom (this will depend on the top part of the gate, our finished top panel measurement was 18 inches). Then starting at the bottom to the marked spot we created a dado. The same 

2. Make sure the fence can support a gate. The size of the gate should not be greater than 4' (1.22 m) in width. If it is wider, you must make and hang two gates, which will meet in the middle. Measure the Connect these to the frame boards that match the rest of the fence by using deck screws, pre-drilling as before. Make 

The structural frame for the gate was made with cedar 2x4s. I cut the members to size and screwed them together using two 3" deck screws at each joint. If you're at all unsure about the exact dimensions you are dealing with, and how long to cut the frame members, make a full-size drawing on some cheap sheet stock to 

Cedar Deck Gate. In no-knot cedar, highest grade exterior wood. In one and two panel styles. You pick the size and slat spacing. T the gates with Olympic Wood Armour seasonally. Gate is built to the opening width, slides into, and snaps into the opening (requires small catch mounted in the doorframe - simple to install).

Product Details

Product List