replacing damaged tongue and groove porch flooring

Watch this video to find out how to remove a rotten wood porch floor, and replace it with pressure treated pine floor joists and tongue and groove flooring. trim around the edges before finish painting. For the longest wear, be sure to apply two good coats of porch and deck enamel to protect the surface from future damage.

Planning a porch floor replacement project. See more ideas about Porch replacement, Front porches and Decking.

This results in a heavy amount of runoff being blown into this end of the porch. For this repair project we milled interlocking tongue-and-groove boards from treated lumber to replace the original rotted porch boards. I decided to replace the entire side of porch flooring with the exception of a roughly 4-ft. span 

Make the cut in a damaged board that's next to a good one and whose groove faces the other boards that will be replaced. (You can spot the tongues Using a pry bar and hammer, remove the old wood on both sides of the cut, being careful not to harm the tongue of the undamaged deck board. Once the waste is clear, 

Remove and replace any nails that have popped with coated screws, and immediately repair or replace loose railings to avoid hazards. To clean everyday dirt Replacing Damaged Deck Flooring Set the first board in tongue first, and insert each board to lock its tongue into the groove of the previous board. Nail each 

DIY Network explains how to replace broken tongue and groove boards in hardwood flooring.

What kind of porch flooring should you use or not use. Awful stuff .from the framing, to the installation of the tongue and groove decking. primer sealer before installing and im going to use screws instead of nails so the the boards can be easily replaced in the future. if i patch other spots on this deck - im 

When you are working with tongue and groove porch flooring, there are things that can go wrong with it. No matter how well you take be around ¾ of an inch. If the proper adjustments are not made, you could end up doing more damage to the brand new board than what is there with the board that needs to be replaced.

Porch floors have more of a tendency to rot than decks because the floorboards are usually set too close together to allow the wood to breathe. Even if the floor If you're replacing tongue-and-groove boards, you have to cut the bottoms of the grooves off the boards that go in the last row with a tablesaw. You then drop the 

Tom Stroup Floor Tongue and Groove Repair and Replacement.

damage the tongue or groove of the sound board next to it. Once you have the first board out, use a cat's paw or pry bar to take out any other damaged pieces. Before putting down the replacement flooring, look carefully at the wood frame underneath. The flooring is nailed to boards called “joists” (see illustration 3). To have 

The flooring may begin to rot, which can cause major damage to the porch if the rot spreads to the joists. Damaged Continue removing all damaged boards in this manner. Squeeze construction adhesive on the exposed joists and place the first board, matching the groove of the new board to the tongue of the old board.

Tongue-and-groove flooring uses a system of interlocking edges tongues and grooves to stay in place with few nails. When floor planks get split or warped, replace them for aesthetic reasons and to prevent further damage to the subfloor. Removing damaged planks takes a bit of effort, but new tongue-and-groove 

Deck Railing Repairs. Your railings might also need to be fixed or replaced to properly support your porch or deck if they are loose or broken. The cost for this project will vary depending on whether you have a simple or ornate railing, and whether just the rail needs to be replaced, or a trim rail, post end caps, balusters, etc.

A 1918 bungalow in Mount Ranier, Maryland, displays beautiful, original tongue-in-groove pine floors that had been covered for decades by vinyl tiles—then When original floors show problems from years of wear, knowing how to replace damaged floorboards or splice in a Dutchman patch is crucial to 

Product Details

Product List